Skip to content
Made by hand in San Diego California since 2009 • Custom made to your size for only $328-$368 • 99% of all orders ship within 24 hours!
Made by hand in San Diego California since 2009 • Custom made to your size for only $328-$368 • 99% of all orders ship within 24 hours!

How To Attach

The Elator is a custom-made external penile support device that consists of two main components (a complete shaft which attaches to one of 4 base rings) 

This video demonstrates The Elator being attached to a completely flaccid penis. The Elator can be attached in as little as 15 seconds. The Elator can be used for men with a full erection, a partial erection or no erection.

 

 

The Elator Components
(A) Soft Flexible Front Loop (stainless steel frame / expanding spring on top / injection molded with medical grade silicone)
(B) Sliding Latch
(C) Support Bars (micro stainless steel rods / wrapped in a medical grade plastic known as PET)
(D) Base Lock Ring
(E) Base Ring (4 sizes included)

To attach, simply follow the below steps or watch this short video.

 

 

Pull Back Foreskin

Fully retract the foreskin under the penis head to expose the penis shaft. Make sure the area behind the head of your penis is fully exposed.
Apply Lubricant

Hold the tip of your non-erect penis and stretch it out as far as you comfortably can. 
Slide Clip Back

Move the sliding latch down to the back clip of the Elator. Spread the flexible ultra-thin stainless steel tubes to open the front flexible loop.
Wrap The Front Loop Around The Area Behind Your Head

Insert your penis head under the flexible front loop, then center the rods and squeeze the front loop together so the loop closes into a circle.
Slide Clip All The Way Up

Move the sliding latch forward all the way, tightening the flexible loop. The sliding latch locks the flexible loop around the penis head.
Attach Base Ring

Use the smallest base ring possible. The base ring should be snug but should not constrict blood flow. Place the base ring over the penis shaft and bring the ring down to the base of the penis.
Clip On Base Ring

Stretch your penis and clip the locking ring to the base ring. If you have a lot of skin around the penis head make sure the skin is not pinched. You should be pointing straight out at 90 degrees once attached.